The Update LED will blink quickly to indicate the update is being applied, this process should continue for approximately 30-60 seconds.The amplifier will appear on your computer as a mass storage device named FENDER_AMP (similar to USB flash and external hard drives).USB Charging cables may not work if data lines are not connected. Connect a USB data cable from the Tone Master amplifier to your MAC or PC.The power jewel located on the front of the chassis will also cycle between amber and red. Once booted (approximately 10-15 seconds), the firmware update LED next to micro-USB port will slowly blink to indicate that the amp is in firmware update mode.Power on the amplifier while holding the firmware update button for at least 3 seconds.Locate the micro-USB port and firmware update button on the underside of the amplifier chassis beneath the OUTPUT POWER section.Download and unzip desired firmware version at the top of this article.Tone Master Deluxe Reverb: Reverb Mod No Bright Cap Firmware v1.1.35 No bright cap on vibrato channel for smoother treble response when using overdrive and distortion pedals at lower settings.Tone Master_Deluxe_RvbMod_NoBrightCap1.1.35
Tone Master Deluxe Reverb: Reverb Mod Firmware v1.1.35 Modified reverb control for easier fine tuning at lower settings.Tone Master Deluxe Reverb: Vintage Spec Firmware v1.0.27 Jensen N12K speaker line out IRs captured with Shure SM57 and Royer 121 microphones.Stock firmware loaded on Tone Master Deluxe Reverb amplifiers with Jensen N12K speaker.Vintage accurate firmware based on vintage and 65 Reissue tube amplifiers.Stock firmware as shipped from the factory is also available below. No update is necessary unless one of the modified versions is desired. Owners of Tone Master Deluxe Reverb amplifiers now have the ability to update their amplifiers with modified firmware that can enhance playability for some users. Fender Tone Master Deluxe Reverb Firmware Updates
0 kommentar(er)
